Step 9 says run the workon command, this command should start up a new
shell with the
working directory being the top level source directory of your sandbox.
This is the directory
you should be in when you run "build setup_all" You do not specify a target
directory for this
command.
What is the fatal error you are getting?
Mike
s h loong
<sloong@detectit To: imc-pfl <imc-pfl@xxxxxxx>
.net> cc:
Sent by: Subject: Problems with Build of Jonah on NT
owner-imc-pfl@ma
il.imc.org
04/17/00 12:31
PM
Hi,
Help needed yet again. We are at step 10 of the instructions andthe build
command does not seem to work.
What directory should we be in when issuing the " build setup_all "
command.
Should we be putting a target directory on the endof the command?. We
tried this but it came back stating that the directory we specified was
not a directory but it is!!.
If we leave a target off we only get FATAL Error message.
Help please
S.H. Loong